Omega-engineering OMG-PCI-DIO48 Manual de usuario descargar pdf (Pagina 6)

Introduction and Installation

OMG-PCI-DIO48 Page 2

System Installation

The OMG-PCI-DIO48 can be installed in any of the PCI expansion slots.

1. Turn off PC power. Disconnect the power cord.

2. Remove the PC case cover.

3. Locate an available PCI slot and remove the blank metal slot cover.

4. Remove the clamping portion of the bracket from the card.

5. Gently insert the OMG-PCI-DIO48 into the slot. Make sure that the

adapter is seated properly.

6. Feed the two 50-pin ribbon cables through the cutout bracket and

connect them to the card.

7. Replace the bracket retaining screw.

8. Install the clamping portion of the bracket

9. Replace the computer cover.

10. Connect the power cord. Installation is complete.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Sin comentarios

Omega-engineering OMG-PCI-DIO48 Manual de usuario Pagina 6